3M™ DS Series Filter Housing
- | Velg produktalternativer for IDer.
Detaljer
Høydepunkter
- 316L stainless steel construction provides excellent corrosion protection for rugged, long-lasting service
- Accepts varying height cartridges – allows use of 1, 2, 3 or 4 standard height cartridges for greater flexibility
- Swing bolt and V Band Clamp closures design optimises cartridge change-out
- Air vent and drain allows venting before start-up and draining for safe filter operation
- Fully supported with a wide range of readily available spares
3M™ DS Housings are our high quality, low costs pressure vessels constructed from 316L stainless steel and have a simple and robust construction. They’re fitted with a V-band clamp or swing bolt closure system for simple and rapid opening and cartridge change-out.
Use 3M™ DS Housings for baton style filter cartridges. They’re suitable for most industrial applications and other processes where 316L materials are required.
Technical support
3M SPSD Hardware team have extensive experience of designing and supplying vessels for baton cartridges.
This experience supports our DS range in service and we support customers that have complex operating situations that need specialist hardware – please contact your local 3M SPSD representative for further information.
Sizes and operating conditions
3M DS housings are produced in two families – 5 round (1, 2, 3 and 4 high) and 12 round (3 and 4 high) and so cover a broad range of Equivalent Standard Length (EQSL) options. Operating conditions are up to 10 bar g and temperatures of up to 110 °C.
Actual operating temperatures will depend on the cartridge types and on the PED 2014/68/CE regulations that are applicable to pressure vessels. They are supplied ready for Double Open Ended (DOE) cartridge use, but can be adapted to Single Open Ended (SOE) use (Type 222 end connections) using an adaptor accessory that is sold separately.
PED 2014/68/CE
3M DS vessels are produced for Article 4.3 ‘Sound Engineering practise’.
Construction materials
Typically, all wetted surfaces are 316L stainless steel with some small parts in polypropylene. Other parts are supplied in 304 stainless steel or similar.
Gaskets
Nitrile gaskets are supplied as standard. A wide range of other gasket materials can also be supplied.
Inlet and outlet options
3M DS housings are supplied with threaded male BSP (05DS family) and DIN inlet / Outlet flanges (12DS family).
Surface finish
3M DS housings have a high-quality pickle passivated interior with an electro-polished exterior finish.
ATEX 2014/34/CE
3M DS housings are approved for use in ATEX condition II 2 GD IIC.
Spesifikasjoner
Ta kontakt med oss, Vi er her for å hjelpe.
Send oss en melding
Takk for din henvendelse til 3M. Informasjonen du oppgir i denne sammenheng vil bli brukt til å svare på din henvendelse, via mail eller telefon, fra en 3M representant eller en av våre autoriserte samarbeidspartnere som vi eventuelt deler personlig informasjon med, iht retningslinjer i 3M Personvernerklæring.
Takk for at du kontakter 3M.
Vi har mottatt meldingen din, og undersøker nå din forespørsel
Én av våre representanter vil ta kontakt med deg på telefon eller e-post
An error occurred.
